![]() ![]() Use this if you want to have an EQ corrected signal " Post EQ" will tap the signal from just after the EQ, before the dynamic effects and the faders.This will give you an almost "raw" signal " Pre EQ" will tap before the EQ and everything else.The " Tap" is from where the signal is recording from.The default is normally from Main L/R and Post fader. Signal source is where you select the signal from.The "Category" table lets you quickly jump through the available Main busses, mixbuses, Matrix, direct outs and monitors.The right hand side is your source selection and where the "Tap" is from.You can adjust this up or down to get a decent recording level from the source ![]()
0 Comments
Leave a Reply. |